Norton Abrasives C3130, C3120, C6120, C3126, C6136, C6130 Depth Gauge and Depth Lock Locations

Depth Lock

The Depth Lock allows the operator to set the cutting depth. When the Depth Lock is used the machine will not lower below the operator preset depth of cut.

To set the Depth Lock:

1.Follow the instructions in sections D. Operating the Saw pages 9 to 21 and E. Cutting Technique subsection Depth Gauge page 22.

2.When the desired depth of cut is reached rotate the Depth Stop Knob clockwise unit it can not be rotated any more. The Depth Stop is now set. A cut will be at this preset depth until the Depth Stop is disengaged by rotating the Depth Stop Knob counter clockwise until it can not be rotated any more.

For example: If the Depth Stop is preset by the operator to 3” the machine will not lower more than 3” below the work surface until the Depth Stop is disengaged.

If the machine will not lower, the Depth Stop has been set. Rotate the Depth Stop Knob counter clockwise to disengage the Depth Stop.

Depth Lock Knob

Depth Gauge

Depth Gauge and Depth Lock Locations

Slowly lower the blade by moving the Raise/Lower Switch forward. For more details on controlling the lowering speed see section Hydraulic System (page

24