Changing the Blade Side:
1.Insure that the Ignition Power Key Switch is in the OFF position and then insert the Blade Shaft Locking Pin into the Blade Shaft Locking hole.
2.Remove the blade shaft screw, (NOTE: Operator’s Right side is a left hand thread and the Operator’s Left side is right hand thread), and remove the outside collar.
3.Clean off any foreign particles on the clamping surfaces of both collars and on the mounting surface of the blade and inspect the both collars for any damage and also inspect the drive pin for damage. Reinstall the Blade Shaft Collars to the machine. NOTE: Replace any damage collars or pins before using the machine.
4.Inspect the blade for any damage, cracks, burnt or blue areas, missing segments, and roundness of blade. Also inspect the arbor hole and drive pin hole to insure both are round. If any problems are found do not use the blade. In addition check that the blade is the correct specification for the application.
5.Remove the Blade Guard by Pulling the Blade Lock Pin out of the Bayonet Mount and lifting the Blade Guard off of the Bayonet Mount.
6.Remove the Blade Shaft Guard by removing the Blade Shaft Guard Locking Pin from the Bayonet Mount and then lift the Blade Shaft Guard off of the Bayonet Mount.
7.Place the blade on the blade shaft, lining up the drive pin hole in the blade with the drive pinhole in the inside collar. NOTE: Diamond blades are direction dependent so verify the direction of rotation of the blade. The machine will rotate the blade into the work surface (down cut). Place the blade guard in position and insert the blade guard retainer pin. Never operate the saw without the blade guard or blade guard retainer pin in position See the following diagram Blade Shaft Installation on page 11.
6.Slide the outside blade shaft collar onto the blade shaft. The drive pin on the outside collar must project through the drive pin hole in the blade and into the inside collar.
8.Tighten the blade shaft screw
12
