M.Allow the engine to warm to operating temperature before use.
N.To adjust the engine speed either:
a.Press the small button located in the center of the Vernier Throttle Control and Pull the large knob of the Vernier Throttle Control towards the rear of the machine to increase the engine speed.
b.Rotate the large knob of the Vernier Throttle Control counter clockwise to increase the engine speed, and rotate the large knob clockwise to decrease the engine speed. Rotating the knob allows for precise adjustments of the engine speed.
O.To turn the engine off turn the Ignition Power Key Switch to the off position.
6.Engine Speed: Always run the engine and the proper speed for the blade being used. Never run the blade at a higher speed that it is rated for. See the Blade Speed chart located on the machine’s console or located in the manual under the heading “Operating the Saw”
To adjust the engine speed either:
A.Press the small button located in the center of the Vernier Throttle Control and Pull the large knob of the Vernier Throttle Control towards the rear of the machine to increase the engine speed.
B.Rotate the large knob of the Vernier Throttle Control counter clockwise to increase the engine speed, and rotate the large knob clockwise to decrease the engine speed. Rotating the knob allows for precise adjustments of the engine speed.
Straight Drive 31 & 61 HP:
Blade | Engine | Engine Pulley | Blade | Blade Shaft | Blade |
Diameter | RPM | Diameter | Shaft RPM | Pulley Diameter | Collar |
|
|
|
|
| Diameter |
14” | 2800 | 4.0 inch | 2560 | 4.38 inch | 4.5 inch |
(356mm) |
| (102 mm) |
| (111mm) | (114mm) |
20” | 2700 | 4.0 inch | 2469 | 4.38 inch | 4.5 inch |
(508mm) |
| (102 mm) |
| (111mm) | (114mm) |
26” | 2400 | 4.0 inch | 2194 | 4.38 inch | 4.5 inch |
(660mm) |
| (102 mm) |
| (111mm) | (114mm) |
30” | 2600 | 4.0 inch | 1340 | 7 inch | 6 inch |
(762mm) |
| (102 mm) |
| (178mm) | (152mm) |
36” | 2500 | 4.0 inch | 1290 | 7 inch | 6 inch |
(914mm) |
| (102 mm) |
| (178mm) | (152mm) |
18
