PRODUCING A TEST PRINT
To check that your printer is operational, produce a test print on a sheet of 80 gsm A4 paper (for example) as follows:
CAUTION!
Allow at least 5 seconds between turning the printer ON after turning it OFF. A shorter time interval between turning ON/OFF operations may cause printer power failure.
Do not turn the printer OFF while it is printing as this may result in damage to the print head.
1.Turn the printer Power Switch to OFF.
2.Set the Paper Type Lever to cut sheet and set the Paper Thickness Lever to position 1.
3.Press and hold the LF button and turn the Power Switch to ON.
4.With the long side of the paper against the paper guide, insert the paper carefully into the printer. The printer will automatically grip the paper and start the test print.
NOTE
If required, you can pause the test print by pressing the SEL button and then resume the test print by again pressing the SEL button.
5.When the test print has completed, the paper is automatically ejected.
NOTE
If you want to abort the test print for any reason, press the SEL button followed by the PARK button to eject the paper and then turn the printer Power Switch to OFF.
Getting started > 14