WARNING!
Do not carry out any operations inside the printer with the Power Switch set to ON.
1.Set the Power Switch to OFF.
2.Tear off any unprinted continuous forms.
3.Open the Rear Cover by gently pulling it out horizontally to the end of its travel then swinging it upwards until it locks into position.
4.Raise each Pin Tractor cover (1) and remove the continuous forms from the Pin Tractors.
1
5.Rotate the Platen Knob and remove the forms from the front or rear of the printer.
6.If a form fragment remains inside the printer, place two or three forms in a stack on the Pin Tractors and turn the Platen Knob to push the fragment out of the printer.
7.When the paper jams are cleared, close the Rear Cover by gently swinging it downwards to the horizontal and then pushing it inwards until it locks into position.
8.Set the Power Switch to ON.
Troubleshooting > 46