ADJUSTING TOF POSITION
Use the following procedure to set TOF to accord with the reference position (6.35 mm (0.25 in)). The reference position refers to the first line of the paper i.e. the position to which the printer feeds the paper when automatically loading the paper.
NOTE
Adjusting of TOF can be done in cut sheet mode or continuous forms mode.
1.Print out the menu settings of the printer as in “Confirming current settings” on page 32 and confirm that the TOF (in cut sheet mode or continuous forms mode) is 6.35 mm (0.25 in).
2.Set the Paper Type lever to the required paper type.
3.When continuous forms are used, place the paper on the Pin Tractor.
For cut sheet mode, do not insert the paper at this stage.
4.In continuous forms mode, press the FF/LOAD button.
In cut sheet manual feeding mode, press the FF/LOAD button and place the paper on the Paper Tray.
After the paper has started to be taken into the printer, continue to press the FF/LOAD button and the paper is taken into the 6.35 mm (0.25 in) position.
5.Align the paper with the first print line position as follows:
In
To feed the paper forward by a small amount, hold down the SHIFT button and press the FF/LOAD button.
To feed the paper backward by a small amount, hold down the SHIFT button and press the LF button.
NOTE
If the specified correction range is more than
6.When the paper is positioned at the required TOF, release the buttons in Step 5 above.
To save this position as the TOF, press the SEL button to
Operating instructions > 41