2.Position the continuous forms supply directly below the printer, no more than 3 cm left or right of the printer paper path.

3.Ensure the rear of the printer is close to and parallel with the edge of the surface and at least 60 cm from any wall.

FEEDING CONTINUOUS FORMS

1.Ensure that the printer is turned ON.

NOTE

If there is a cut sheet in the printer, eject it as described in “Ejecting cut sheet paper” on page 20.

2.Ensure the Paper Type Lever (1) is set to Continuous

Forms.

1

3.Adjust the Paper Thickness Lever to suit the paper. See “Setting the Paper Thickness lever” on page 26.

NOTE

If the Paper Thickness Lever setting does not match the paper being used, paper feeding and printing may not work properly.

4.Open the Rear Cover by gently pulling it out horizontally to the end of its travel then swinging it upwards until it locks into position.

Paper handling > 21