Olympus P-S100 user manual Introduction, EN-2, For customers in North and South America

Doya_E.book Page 2 Thursday, November 11, 2004 10:50 AM

Introduction

Introduction

Read this manual carefully prior to use to ensure correct use of this product.

For customers in North and South America

For customers in USA

Declaration of Conformity

Product Name	: Digital Photo Printer
Model Number	: P-S100
Trade Name	: OLYMPUS
Responsible Party	:
Address	: Two Corporate Center Drive, PO Box 9058, Melville,
	NY 11747-9058 U.S.A.
Telephone Number	: 1-631-844-5000

Tested To Comply With FCC Standards

FOR HOME OR OFFICE USE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference received, including interference that may cause undesired operation.

FCC Notice

• Radio and Television Interference

Change or modifications not expressly approved by the manufacturer may void the user’s authority to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Adjust or relocate the receiving antenna.

-Increase the distance between the equipment and receiver.

-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

-Consult your dealer or an experienced radio/TV technician for help. Only the OLYMPUS-supplied cables should be used to connect this product to other products.

WARNING: The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC Certification of this device and may cause interference levels which exceed the limits established by the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded equipment interface cable with device. Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

Any unauthorized changes or modifications to this equipment would void the user’s authority to operate.

For customers in Canada

This Class B digital apparatus complies with Canadian ICES-003.

EN-2