Olympus P-S100 user manual Connecting a PC to the printer, Printing pictures, EN-28

Doya_E.book Page 28 Thursday, November 11, 2004 10:50 AM

Printing pictures from a PC

Printing

Connecting a PC to the printer

Use a commercially available USB cable (A-B type, less than 3m (9.8 ft.)).

1Plug one end of the USB cable into the USB port on the PC, and then plug the other end into the USB connector on the rear of the printer.

2Turn on the printer.

Notes

•When this printer is connected both to a PC and a PictBridge-compatible digital camera, it assigns higher priority to the digital camera. Disconnect the digital camera.

•This printer's performance is not guaranteed in a network environment.

•This printer's performance is not guaranteed when connected to a USB hub.

Printing pictures

1In your application, display and select the pictures to be printed.

2On the print screen, select [P-S100] from the available printer list.

Note

[Print] operations and printer selection vary depending on the application. Refer to the manual supplied with your application.

3On the print setting screen, check the paper size and other properties, and then start printing.

For details, refer to “Setting the print properties” (gpage 29).

Notes

•Printing will stop if you unplug the power cord during printing. The paper should be automatically ejected when you turn on the printer again. If it is not, refer to “When paper is jammed” (gpage 36).

•Do not open the ribbon cartridge door or remove the paper-in tray during printing.

•Do not move the printer during printing.

•Do not turn off the printer or PC, or disconnect the AC adapter during printing. If you inadvertently turn off the printer or disconnect the AC adapter, turn on the printer and then try printing again. If you leave the printer as is, a failure might occur.

EN-28