Olympus P-S100 user manual Error signals, EN-33, Indicator Printer status Solution Pages Status

Doya_E.book Page 33 Thursday, November 11, 2004 10:50 AM

			Error signals
Error signals
					Additional
Indicator	Indicator	Printer status	Solution	Page(s)
	status
POWER	On	Power ON	–	18
	Off	Power OFF			information
ACCESS	On*	Connected to a	Wait for a while. Do not disconnect
		digital camera, or	the digital camera or PC.
		the printer is		–
		cooling off
	Blinking	Communicating
	slowly
	Blinking	Printing	–	–
	very slowly
PAPER	Blinking	Out of paper	Replace the paper-in tray.	22, 32
	slowly
RIBBON	Blinking	End of ink	Replace the ribbon cartridge with a	19, 32
	slowly	ribbon	new one.
		No ribbon	Set a ribbon cartridge into the printer.	19
		cartridge is set
		The paper and	Use a ribbon cartridge for 100 × 148	21
		the ribbon	mm (4 × 6) printing when printing on
		cartridge are	100 × 148 mm (4 × 6) papers, and use
		incompatible	a ribbon cartridge for 89 × 127 mm
			(3.5" × 5") printing when printing on
			89 × 127 mm (3.5" × 5") papers.
ACCESS and	Blinking	Paper jam	Remove jammed paper.	36
PAPER	together
ACCESS and	Blinking	Communication	Check whether the digital camera	–
RIBBON	together	error	supports PictBridge.
			Turn the printer off and on, then try
			printing again. If the error persists,	–
			contact an authorized Olympus
			service center.
ACCESS, RIBBON,	Blinking	Internal problem	Contact an authorized Olympus	–
and PAPER	together		service center.

* This light goes off when the connection is complete.

EN-33