Omega C4EIT/-EIT manual ISeries?

Appendix H Telnet Setup (continued)

sIs the configuration command, used to set a new setting (see the example in Figure I-3)

RESET Following with a return character, it will recycle the Power on the iServer.

FACTORY Following with a return character, it will set the iServer to it’s factory default settings.

cThe current settings will be stored permanently .

q quit

Administrator Password?00000000

iSeries>?
Available Commands:
1.	RESET	(To reboot the device)
2.	FACTORY	(To restore factory defaults)
3.	?	(Help/This screen)
4.	c	(confirm settings and write to the flash)
5.	p	(Print the settings)
6.	q	(Quite this console)
7.	s-<ARG><VALUE>	(To change device settings)

+-------------------------------------------------------------			+
Arg	Description	Value
+-------------------------------------------------------------			+
BD	BaudRate	1-300, 2-600, 3-1200,
		4-2400, 5-4800, 6-9600,
		7-19200, 8-38400
		9-57600, 10-115200,
		11-230400, 12-460800
DT	Data Bits	1-5 bits, 2-6 bits,
		3-7 bits, 4-8 bits
PT	Parity	1-none, 2-even, 3-odd
ST	Stop Bit	1-1 bit, 2-2 bits
FC	FlowControl	1-none, 2-hw, 3-sw
DP	DHCP	0-Disable, 1-Enable
IP	IP address
SM	Subnet mask

54