4
4
37
37
HOSEFITTING
Theinput port(s) on the instrument are designed to accept a hose
with4mm I.D. and 1mm wall. Thehose is fitted by unscrewing the
clampingnut, sliding the hose on to the stepped shaft and refitting
thenut.
Note:Do not tighten fittings attached to the pressure ports to a torque
greaterthan 2Nm otherwise the pressure seals may be damaged.
HOSEFITTING
Theinput port(s) on the instrument are designed to accept a hose
with4mm I.D. and 1mm wall. Thehose is fitted by unscrewing the
clampingnut, sliding the hose on to the stepped shaft and refitting
thenut.
Note:Do not tighten fittings attached to the pressure ports to a torque
greaterthan 2Nm otherwise the pressure seals may be damaged.
HANDPUMP OPERATION(if applicable)
T+Usethe pieceto connect the hand pump to the instrument’s
portand to the equipment being tested. Exhaust the system by
turningthe release valve on the hand pump anti-clockwise and set
thefine adjustment threaded piston to mid range.
Closethe release valve and apply pump action to the hand pump
pistonto generate the required approximate pressure. Fine
adjustmentof the desired pressure can then be made by rotating the
threadedpiston. Therelease valve may be used to vent the system.
Note:The hand pump is capable of generating 7bar max. Itis,
therefore,essential that extra care is taken not to over-pressure the
instrument.
Apump must not be used on models HHP-2000, 2020 and 2080
HANDPUMP OPERATION(if applicable)
T+Usethe pieceto connect the hand pump to the instrument’s
portand to the equipment being tested. Exhaust the system by
turningthe release valve on the hand pump anti-clockwise and set
thefine adjustment threaded piston to mid range.
Closethe release valve and apply pump action to the hand pump
pistonto generate the required approximate pressure. Fine
adjustmentof the desired pressure can then be made by rotating the
threadedpiston. Therelease valve may be used to vent the system.
Note:The hand pump is capable of generating 7bar max. Itis,
therefore,essential that extra care is taken not to over-pressure the
instrument.
Apump must not be used on models HHP-2000, 2020 and 2080
PLUSFUNCTIONS
ModelsHHP-2020, 2021, 2022, 2023, 2024, 2025, 2080, 2081,
2082,2084, 2085
PLUSFUNCTIONS
ModelsHHP-2020, 2021, 2022, 2023, 2024, 2025, 2080, 2081,
2082,2084, 2085
SMOOTHINGMODE
Press keyandthe instrument continuously averages the last four
measurementsto give a more stable reading on the display. Press
keyagain to return to normal measurement.
=
=
SMOOTHINGMODE
Press keyandthe instrument continuously averages the last four
measurementsto give a more stable reading on the display. Press
keyagain to return to normal measurement.
=
=
UNITSOF PRESSURE
Press keyto select required units of pressure. Chosenunits will
besaved when the instrument is switched off.
Pleaserefer to the table on the back page.
TheHHP-20x0 0-25mbar instruments cannot show the µbar or mmHg
symbolson their displays. Whenswitching the units on they are
readingin µbar and so show no unit symbol. Pushingthe autorange
buttonwill put the unit into mbar and show the mbar symbol. When
readingin mmHg only the symbol Hg will show on the display.
Thisfunction will not operate while in store mode.
Note:HHP-2024 - 2084
K=x10whenusing in H Oand Pa.
M=x10whenusing in H Oand Pa.
32
62
UNITSOF PRESSURE
Press keyto select required units of pressure. Chosenunits will
besaved when the instrument is switched off.
Pleaserefer to the table on the back page.
TheHHP-20x0 0-25mbar instruments cannot show the µbar or mmHg
symbolson their displays. Whenswitching the units on they are
readingin µbar and so show no unit symbol. Pushingthe autorange
buttonwill put the unit into mbar and show the mbar symbol. When
readingin mmHg only the symbol Hg will show on the display.
Thisfunction will not operate while in store mode.
Note:HHP-2024 - 2084
K=x10whenusing in H Oand Pa.
M=x10whenusing in H Oand Pa.
32
62
MAX/MINRECORDER
Press key to start. Theinstrument will display alternating
symbolsand current reading. Pressagain to display the
maximumpressure reading and symbol will be displayed.
Pressagain to display the minimum pressure reading and
symbolwill be displayed. Pressagain to return to the actual
pressuredisplay.
Press keytodisplay the average pressure since the MAX/MIN
modewas activated and symbolwill appear on display.
Press keyagainto return to actual pressure display.
MAX/MINRECORDER
Press key to start. Theinstrument will display alternating
symbolsand current reading. Pressagain to display the
maximumpressure reading and symbol will be displayed.
Pressagain to display the minimum pressure reading and
symbolwill be displayed. Pressagain to return to the actual
pressuredisplay.
Press keytodisplay the average pressure since the MAX/MIN
modewas activated and symbolwill appear on display.
Press keyagainto return to actual pressure display.
X
X
X
X
ServicingUSA and Canada: Call OMEGAToll Free
ServicingUSA and Canada: Call OMEGAToll Free
ServicingEurope: United Kingdom Sales and Distribution Centre
ServicingEurope: United Kingdom Sales and Distribution Centre
TheOMEGA Complete Measurement and
ControlHandbooks & Encyclopedias
TheOMEGA Complete Measurement and
ControlHandbooks & Encyclopedias
USA
OneOmega Drive, Box 4047
Stamford,CT 06907-0047
Telephone:(203)359-1660
FAX:(203)359-7700
USA
OneOmega Drive, Box 4047
Stamford,CT 06907-0047
Telephone:(203)359-1660
FAX:(203)359-7700
Canada
976Bergar
Laval(Quebec) H7L 5A1
Telephone:(514)856-6928
FAX:(514)856-6886
Canada
976Bergar
Laval(Quebec) H7L 5A1
Telephone:(514)856-6928
FAX:(514)856-6886
SalesService: 1-800-826-6342 / 1-800-TC-OMEGA
CustomerService: 1-800-622-2378 / 1-800-622-BEST
SM
SM
SM
EngineeringService: 1-800-872-9436 / 1-800-USA-WHEN
TELEX:996404 EASYLINK:62968934 CABLE:OMEGA
SalesService: 1-800-826-6342 / 1-800-TC-OMEGA
CustomerService: 1-800-622-2378 / 1-800-622-BEST
SM
SM
SM
EngineeringService: 1-800-872-9436 / 1-800-USA-WHEN
TELEX:996404 EASYLINK:62968934 CABLE:OMEGA
25Swannington Road, BroughtonAstley,
LeicestershireLE9 6TU, England
Telephone:44(1455) 285520 FAX:44 (1455) 283912
25Swannington Road, BroughtonAstley,
LeicestershireLE9 6TU, England
Telephone:44(1455) 285520 FAX:44 (1455) 283912
4
4
4
4
4
4
4
4
4
4
4
4
4
4
Temperature
Temperature
DataAcquisitionSystems
DataAcquisitionSystems
Pressure,Strain & Force
Pressure,Strain & Force
ElectricHeaters
ElectricHeaters
Flowand Level
Flowand Level
EnvironmentalMonitoring
andControl
EnvironmentalMonitoring
andControl
pHand Conductivity
pHand Conductivity
Callfor your FREE Handbook Request Form today: (203) 359-RUSH
Callfor your FREE Handbook Request Form today: (203) 359-RUSH
AnOMEGA Technologies Company
®
AnOMEGA Technologies Company
®