One for All (URC-8910) USING VOLUME LOCK

USING VOLUME LOCK

In its default (unlocked) state,the URC-8910 remote controlallows

each device to control its own volume only in its own mode (e.g.,TV

volumei n the TV mode, VCRvolume in VCRmode, etc.).However,

using our Volu me L oc k feature,you can lock the volume controls for

each device to all modes (e.g.,RCVR/AMP volume in all modes).

Moreover,using the Volume Unlockfeature (see the next page),

you can further customize the settings so that a device’s volume

controls are unlocked in one mode,but remain locked in all other

modes (e.g.,TV volume in the TV mode and RCVR/AMP vo lume in

other modes).

1. On the URC-8910 remote control,press and hold

SETuntil you see the display change from the cur-

rent device and time to [CODE SET].

NOTE:The device, its code,and time are examples.Your

remote control settings may be different.

NOTE:To exit programming at any time,press

EXIT

once or

allow 30 seconds ofinactivity to lapse.You will see

[EXIT

SETUP]

as the remote control returns to normal operation.

NOTE:

[INVALID]

means you have inadvertently pressed an

incorrect key.Note your error and continue programming.

2. Press the ▼key four times until you see the display

change to [VOL LOCK].

(x 4)

NOTE:If you go past

[VOL LOCK]

,press the

▲

key one or

more times to return to it.

3. Press SELECTonce to begin programming.You will

see the display change to [TO MODE].

4. Press a mode key (e.g.,RCVR/AMP) to lock a device’s

volume controls to all modes.You will see the display

change to [SUCCESS]and then [EXIT SETUP] as the

remote control automatically exits the programming

mode and returns to normal operation.

5. Ifdesired, repeat steps 1 through 4 as needed to lock

volume controls for other devices to all modes.

SELECT