USING CHANNEL SCAN
In the TV,VCR,DVD,SAT,and CBLmodes, use the FAVkey to start a
3-second scan ofall favorite channels (if programmed – see
Programming Favorite Channel Scanbelow) and/or all channels for
the selected mode.
1. IfFavorite Channel Scan has been set up,skip to
step2.Otherwise, on the URC-8910 remote control
press TV,VCR,DVD,SAT,or CBLonce.
2. Press FAVonce.
•IfFavorite Channel Scan has been set up,scanning
offavorite channels will start and, upon comple-
tion,continue to scan all channels upward for the
same device.
•IfFavorite Channel Scan has not been set up,
scanning will start with the current channel,then
proceed to the next channel up,and continue
until all channels ofthe selected device is
scanned.You will see the LED(red light) and IR
transmission icon ( ) blink each time a channel
is scanned.
3. To stop scanning channels at any time,press any key
once (except the backlight key ).
PROGRAMMING FAVORITE CHANNEL SCAN
In the TV,VCR,DVD,SAT,or CBLmode,you can store a list of up to
10favorite channels,in any order, that wi l l b e immediately scanned
when FAVis pressed (see Using Channel Scan above).
NOTE:Only channels of one mode can be stored for Favorite Channel Scan.
1. On the URC-8910 remote control,press and hold
SETuntil you see the display change from the cur-
rent device and time to [CODE SET].
NOTE:The device, its code,and time are examples.Your
remote control settings may be different.
NOTE:To exit programming at any time,press
EXIT
once or
allow 30 seconds ofinactivity to lapse.You will see
[EXIT
SETUP]
as the remote control returns to normal operation.
NOTE:
[INVALID]
means you have inadvertently pressed an
incorrect key.Note your error and continue programming.
continued on next page...
41