RE-ASSIGNING DEVICE KEYS (continued)
To re-assign other device keys to the AUXkey,repeat step s 1 through
6 on the previous page but substitute the key sequence from the
below chart:
To Re-Assign Device Key Perform Sequence
AUX as 2nd TV key: SET*- ▼(x 7)- SELECT - TV - AUX
AUX as 2nd DVD key: SET*- ▼(x 7)- SELECT
-DVD- AUX
AUX as 2nd SAT key: SET*- ▼(x 7)- SELECT
-SAT- AUX
AUX as 2nd CD key: SET*- ▼(x 7)- SELECT
-CD- AUX
AUX as 2nd CBL key: SET*- ▼(x 7)- SELECT
-CBL- AUX
AUX as 2nd RCVR/AMP key: SET*- ▼(x 7)- SELECT- RCVR/AMP - AUX
*NOTE:Press and hold
SET
(see step 1 on previous page).
You can also re-assign another unused device key by substituting an
open key for the AUXkey in the above chart and performing the
sequence.For example,to re-assign an unused SAT key as a second
CDkey, perform SET*- ▼(x 7) - SELECT - CD - SAT.
USING KEYMOVER
The URC-8910 remote control includes a Keymoverfeature that
allows you to map (or copy) keys from one mode (i.e.,source mode)
to another mode (i.e.,destination mode).
NOTE:The following keys cannot be used as a source or destination:
TV
,
VCR
,
DVD
,
AUX
,
SAT
,
CBL
,
RCVR/AMP
,
CD
,
HOMETHEATER
,and
SET
.

Programming Keymover

For example,if your VCR does not have volume control,try mapping
the volume and mute keys from TV mo de to VCRmode as follows:
1. On the URC-8910 remote control,press and hold
SETuntil you see the display change from the cur-
rent device and time to [CODE SET].
NOTE:The device, its code,and time are examples.Your
remote control settings may be different.
NOTE:To exit programming at any time,press
EXIT
once or
allow 30 seconds ofinactivity to lapse.You will see
[EXIT
SETUP]
as the remote control returns to normal operation.
NOTE:
[INVALID]
means you have inadvertently pressed an
incorrect key.Note your error and continue programming.
2. Press the ▼key eight times until you see the display
change to [KEYMOVER].
(x 8)