One for All (URC-8910) Programming A Master Power Key With Instant Channel Selection

5. Enter a macro sequence ofup to 15 keys.For our
example,press the following keys once in this order:
TV- 7-1
NOTE:If you have access to over 100 channels,add a 0
before the channel numbers (e.g., 0 - 7 - 1 ).If the original
remote control requi re d pressing an Enter key to change the
channel,also press the
Enter key after the channel number
(e.g.,
0 - 7 - 1 - ENTER ).
NOTE:An
[ERROR] message,followed by [MAX = 15] alerts
you that the macro sequence must be 15 keys or less.
After pressing the first key (in the macro sequence),
you will see the display change to [SEL TO END].This
message acts as a reminder to use SELECTto end the
sequence (see next step).
6. To end the macro sequence,press and hold SELECT
until you see [SUCCESS]appear in the display,
followed by [EXIT SETUP].The URC-8910 remote
controlwill automatically exit the programming
mode and return to normal operation.
Now when you press M1,you will instantly see cable channel 71 on
your TV set.
Programming A Master Power Key With Instant
Channel Selection
A macro key can be programmed to turn on and offyour devices as
well.For example,let’s set up a sequence that will turn on the TV
and tune it to channel3, and then turn on the cable converter and
tune it to a premium channel (e.g.,11).
NOTE:This example assumes all equipment is turned offand that the TV is
connected through the cable converter with TV tuning set to channel 3.
1. Perform steps 1 through 4 ofthe previous section,
Programming A Favorite Channelon page 34.
However,this time in step 4,substitute another open
macro key (e.g.,M2).
2. Enter a macro sequence ofup to 15 keys.For our
example,press the following keys once in this order:
CBL- POWER - TV - POWER - 0-3 - CBL- 1-1
NOTE:If you have access to over 100 channels,add an 0
before each set ofchannel numbers (e.g., 0 - 0 - 3 and 0 - 1 - 1 ).
Ifth e original remote c ontrol required pressing an Enterkey
to change the channel,also press the
Enter key after each
channel number (e.g.,
0 - 0 - 3 - ENTER and 0 - 1 - 1 - ENTER ).
continued on next page...
SELECT
35