Onkyo CR-L5 instruction manual Abnormal Behavior, Restoring the Default Settings

CR-L5_E.book Page 31 Monday, May 19, 2003 4:05 PM

Troubleshooting—Continued

Trouble	Possible Cause	Remedy
It takes a long time to locate	The disc is dirty.	Remove the disc and clean it (page 6).
certain tracks?	The disc is very scratched.	Buy a new disc.
	CT (Clock Time) information has been	Set ACCUCLOCK to use a specific station
The clock is wrong?	taken from a radio station in another time
		(page 17).
	zone.
The CR-L5 turns itself on	The ACCUCLOCK function is updating the	This is not a malfunction. The CR-L5 will
		turn itself off automatically when the ACCU-
unexpectedly?	clock.
		CLOCK function has updated the clock.
	The CR-L5 was already on at the specified	Set the CR-L5 to Standby (page 27). The CR-
		L5 must be in Standby mode, otherwise the
	ON time.
The timer didn’t work?		timed task will not work.
	The specified ON time coincided, or over-	Check the timer settings and correct as neces-
	lapped the ON time of another timer.	sary (page 28).
	While a timed recording task is in progress,	To hear what’s being recorded, press the
No sound is output when a		[MUTING] button to cancel the Mute func-
	the output of the CR-L5 is muted.
timed playback or record-		tion. Press it again to mute the CR-L5.
ing task starts?	For timed playback, the volume is deter-	Set the volume to a suitable level (page 19).
	mined by the VOLUME control.

Abnormal Behavior

The CR-L5 contains a microcomputer for signal processing and control functions. In very rare situations, severe interfer- ence, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

Restoring the Default Settings

To reset the CR-L5 to its factory defaults, turn it on and, while holding down the STOP [] button, press the [STANDBY/ ON] button. Press the [STANDBY/ON] button again. “Initialized” appears on the display and the CR-L5 is reset to its factory defaults.

31