Onkyo TX-NR509 Presetting AM/FM Stations, Using RDS excluding North American and Taiwan models

■Manual tuning mode

In manual tuning mode, FM stations will be in mono.

1	Press TUNING MODE so that the AUTO indicator
	goes off on the display.
2	Press and hold TUNING q/w.
	The frequency stops changing when you release the
	button.

Press the buttons repeatedly to change the frequency one step at a time.

■Tuning into stations by frequency

You can tune into AM and FM stations directly by entering the appropriate frequency.

1	On the remote controller, press TUNER repeatedly
	to select “AM” or “FM”, followed by D.TUN.
	(Actual display depends on the country.)
2	Within 8 seconds, use the number buttons to enter
	the frequency of the radio station.

For example, to tune to 87.5 (FM), press 8, 7, 5.

If you have entered the wrong number, you can retry after 8 seconds.

Presetting AM/FM Stations

You can store a combination of up to 40 of your favorite AM/FM radio stations as presets.

1	Tune into the AM/FM station that you want to
	store as a preset.
	See the previous section.
2	Press MEMORY.
	The preset number flashes.

(Actual display depends on the country.)

3	While the preset number is flashing (about 8
	seconds), use PRESET e/rto select a preset from
	1 through 40.
4	Press MEMORY again to store the station or
	channel.

The station or channel is stored and the preset number stops flashing.

Repeat this procedure for all of your favorite AM/FM radio stations.

En

■Selecting Presets

1 To select a preset, use PRESET e/ron the AV

receiver, or the remote controller’s CH +/–.

Tip

•You can also use the remote controller’s number buttons to select a preset directly.

■Deleting Presets

1	Select the preset that you want to delete.
	See the previous section.
2	While holding down MEMORY, press TUNING
	MODE.

The preset is deleted and its number disappears from the display.

Using RDS (excluding North American and Taiwan models)

RDS works only in areas where RDS broadcasts are available.

When tuned into an RDS station, the RDS indicator lights. When the station is broadcasting text information, the text can be displayed.

■What is RDS?

RDS stands for Radio Data System and is a method of transmitting data in FM radio signals. It was developed by the European Broadcasting Union (EBU) and is available in most European countries. Many FM stations use it these days. In addition to displaying text information, RDS can also help you find radio stations by type (e.g., news, sport, rock, etc.).

The AV receiver supports four types of RDS information:

PS (Program Service)

When tuned to an RDS station that’s broadcasting PS information, the station’s name will be displayed. Pressing DISPLAY will display the frequency for 3 seconds.

RT (Radio Text)

When tuned to an RDS station that’s broadcasting text information, the text will be shown on the display as described in the next section.

PTY (Program Type)

This allows you to search for RDS radio stations by type

(➔ page 27).

TP (Traffic Program)

This allows you to search for RDS radio stations that broadcast traffic information (➔ page 27).

Note

•In some cases, the text characters displayed on the AV receiver may not be identical to those broadcast by the radio station. Also, unexpected characters may be displayed when unsupported characters are received. This is not a malfunction.

•If the signal from an RDS station is weak, RDS data may be displayed intermittently or not at all.

26