Before using the unit
Setting the voltage selector (Worldwide models only)
Worldwide models are equipped with a voltage selector to conform with local power supplies. Be sure to set this switch to match the voltage of the power supply in your area before plugging in the unit.
Determine the proper voltage for your area:
ANTENNA | AM | FM |
75 |
FRONT | FRONT | SURROUND | AC OUTLET |
SPEAKERS A | SPEAKERS B | SPEAKERS |
|
|
|
|
|
|
|
|
|
| L |
| L | CENTER |
DIGITAL INPUT |
| VIDEO 2 | VIDEO 1 | DVD | MONITOR | L |
| SPEAKER | ||||
|
|
| REMOTE | IN | OUT | IN | IN | OUT |
|
|
| |
OPTICAL | COAXIAL |
|
|
|
|
| ||||||
CONTROL |
|
|
|
|
|
|
|
|
| |||
2 | 1 |
|
|
|
|
|
|
| VIDEO |
|
|
|
|
|
|
|
|
|
|
|
| R | R | R |
|
|
|
|
|
|
|
|
|
| S VIDEO |
|
| VOLTAGE |
|
|
|
|
|
|
|
|
|
|
|
| SELECTOR |
IN | OUT | IN |
| IN | OUT | IN | FRONT | SURR | CENTER |
|
| 120V |
|
|
|
| |||||||||
|
|
| L |
|
|
|
| L |
|
|
|
|
SUBWOOFER |
|
|
|
|
|
|
|
|
|
| ||
PRE OUT |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| R |
|
|
|
|
|
|
|
|
|
CD | TAPE |
| VIDEO 2 | VIDEO 1 |
| R | SUB |
|
|
| ||
|
| DVD | WOOFER |
|
|
| ||||||
VOLTAGE
SELECTOR
120V 
Setting the AM tuning step frequency (Worldwide models only)
Refer to page 24 to set the AM tuning step frequency correctly.
Notes
•Do not mix new batteries with old batteries or different kinds of batteries.
•To avoid corrosion, remove the batteries if the remote controller is not to be used for a long time.
•Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, replace both batteries at the same time.
•The life of the supplied batteries is about six months but this varies depending on usage.
Using the remote controller
Point the remote controller toward the remote control sensor. The STANDBY indicator lights up when the unit receives a signal from the remote controller.
Remote control sensor
Receiver
STANDBY indicator 
30˚
30˚
Inserting the batteries
1 Detach the battery cover.
2Insert the two size AA/R6/UM3 batteries.
Be sure to match the + and – ends of the batteries with the diagram inside the battery compartment.
3 Attach the battery cover.
Notes
•Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller.
•Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference.
•Do not put any object (such as a book) on the remote controller. The buttons of the remote controller may be pressed by mistake and drain the batteries.
•Make sure the audio rack doors do not have colored glass. Placing the unit behind such doors may prevent proper remote controller operation.
•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.
5
