Optima 45 - 3 | 32 |
LIGHTING INSTRUCTIONS ON RATING PLATE
LIGHTING INSTRUCTIONS
1.STOP! Read the safety information above on this label.
2.Set the remote switch to “OFF”. Set the thermostat to the lowest setting. (Only if your appliance is equipped with these devices.)
3.Turn off all electric power to the appliance.
4.Open lower louvers or access door.
3.Press slightly and turn the control knob clockwise 3 to the “OFF” position.
4.Wait 5 minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! and follow instruction “B” above.
5.Find pilot. It is located between the logs near the center behind the burner.
6.Press slightly and turn control knob counterclockwise 4 to “PILOT”. Depress knob and light pilot by repeatedly pressing the sparker. Once flame is established, hold knob
depressed for approximately 30 seconds. Release knob. If pilot should go out, repeat steps 3 to 5.
•If the knob does not pop up when released, stop and immediately call your service technician or gas supplier.
•If the pilot will not stay lit after serveral tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.
7.If the appliance has a manual valve, turn gas control knob counterclockwise 4 to the desired heat setting from “LO” to “HI”. If the appliance has an automatic valve, turn gas control knob counterclockwise 4 to “ON” and set the flame adjustment knob to the desired heat setting from “LO” to “HI”.
8.Set the remote switch to “ON”. Set the thermostat to the desired setting. (Only if your appliance is equipped with these devices.)
9.Turn on all electric power to the appliance.
10.Close louver or access door.
