Orion Car Audio HCCA10002, HCCA10004 owner manual Five Channel Configuration

Five Channel Configuration

ssChannels 1/2 are configured for 2-channel stereo operation.

ssChannel 1/2 lowest recommended impedance is 2Ω stereo. Lowest recommended impedance is 2Ω stereo and 4Ω bridged mono.

ssRear outputs must be set for full range operation.

ssPassive crossovers must be used on all components and frequen- cies must not overlap.

LF LR

Tri-Mode Six Channel Configuration

ssLowest recommended impedance is 2Ω stereo and 4Ω bridged mono.

ssFront and rear outputs must be set for full range operation.

ssPassive crossovers must be used on all components and frequen- cies must not overlap.

WARNING! Failure to observe these requirements may result in dam- age to the amplifier.

LF LR

RF RR

Figure 19

Figura 19

Abbildung 19

NOTE: To get full output in this configuration, band limiting filters as shown in this diagram may need to be used to prevent the impedance from dropping too low and engaging protection circuits.

RF RR

Figure 20

Figura 20

Abbildung 20

NOTE: To get full output in this configuration, band limiting filters as shown in this diagram may need to be used to prevent the impedance from dropping too low and engaging protection circuits.

© 2009 Directed Electronics. All rights reserved. 14