Orion Car Audio HCCA10002, HCCA10004 owner manual 0ANELN,AYOUT, Figura

1	2	3	4
B+	REM	GND
	POWER

		Recommended wire stripping lengths (L):
Figure 3		Insulated Wire L (for Power wires):	1.0” (25 mm)
Figura 3		L (for Speaker wires):	0.5” (13 mm)
	L
Abbildung 3		L (for Remote wires):	0.5” (13 mm)

1.+BAT - connect this terminal through a FUSE or CIRCUIT BREAKER to the positive terminal of the vehicle battery or the positive ter- minal of an isolated audio system battery.

WARNING: Always protect this power wire by installing a fuse or circuit breaker of the appropriate size within 12 inches of the battery terminal connection.

2.REM - this terminal turns on the amplifier when (+) 12 volt is applied. Connect it to the remote turn on lead of the head unit or signal source. If a (+) 12 volt remote turn lead is not available, a Remote Power Adapter (P/N ORRPA) can be used to supply a remote turn on signal. DO NOT connect this terminal to constant

(+) 12 volt.

 GND - power return connection. Connect this terminal directly to the sheet metal chassis of the vehicle, using the shortest wire necessary to make this connection. Always use wire of the same gauge or larger than the (+) 12 volt power wire. The chassis con- nection point should be scraped free of paint and dirt. Use only quality crimped and/or soldered connectors at both ends of this wire. DO NOT connect this terminal directly to the vehicle battery

ground terminal or any other factory ground points.

4.Top cover lock - Use the key provided or the 3mm hex key to unlock and remove the top cover.

NOTE: Make all connections to power, ground, speakers, and remote terminals before final positioning and installation of the amplifier in the vehicle. The top cover needs to be removed to fasten some of the connections. These connections once made are secured by tightening the set screws with the Allen wrench provided. These fastening set screws are labeled and located on top of the amplifier at either end, directly above their associated connectors.

4/0/0ANELN,AYOUT

NOTE: Top cover must be removed to access the following controls (Refer to the Removing the Top Cover section of this manual). These controls are duplicated for the HCCA10004 (a separate set of controls for Front and Rear channels).

	1		2	3				4
			X-OVER
HIGH							LOW
PASS		LOW	ALL	SLOPE			PASS
			HIGH
50	2K			24dB			50	2K
				12dB
HZ	HZ						HZ	HZ
		HIGH		OFF
MIN	MAX	LOW 15	60	ON	0	10	20	200
GAIN		HZ	HZ		dB	dB	HZ	HZ
		GAIN			Q		FREQ
Figure 4		RANGE
			INFRASONIC			INTELLI-Q
Figura 4
Abbildung 4	10	9	8	7	6			5

© 2009 Directed Electronics. All rights reserved. 4