Orion Car Audio HCCA10002 3PEAKERA#ONNECTIONSC##!, One Channel/Two Channel Configuration

3PEAKERA#ONNECTIONSC(##!

The Orion HCCA10002 amplifier offer one positive and one negative output terminal for ease of connecting channel 1(L CH) and/or 2(R CH) outputs to the speakers. The amplifier is stable to 2Ω per channel. See diagrams below.

One Channel/Two Channel Configuration

ssLowest recommended impedance is 2Ω stereo.

ssOutputs can be configured for high-pass, low-pass, or full range operation.

_	+	_	+
	L CH		R CH

Figure 14

Figura 14

Abbildung 14

Bridge Configuration

Bridging allows one speaker to be driven at a higher power level from the amplifier.

ssThe bridged outputs lowest recommended impedance is 4Ω.

_	+	_	+
	L CH		R CH

Figure 15

Figura 15

Abbildung 15

Three Channel (L Channel, R Channel, Bridged)

ssLeft and Right are configured for two-channel stereo operation.

ssLowest recommended impedance is 2Ω stereo.

ssThe third output is configured for a single channel bridged out- put.

ssThe bridged outputs lowest recommended impedance is 4Ω.

ssOutputs are configured for high-pass, low-pass, or full range operation.

_	+	_	+
	L CH		R CH

Figure 16

Figura 16

Abbildung 16

NOTE: To get full output in this configuration, band limiting filters as shown in this diagram may need to be used to prevent the impedance from dropping too low and engaging protection circuits.

© 2009 Directed Electronics. All rights reserved. 12