Panasonic AG-DVX100A manual Auto SW screen, Playback Functions screen

Setting menus

AUTO SW screen

Item/	Description of settings
(display mode)
A. IRIS	ON:
(Camera)	When the AUTO button is pressed, the
	auto iris control operation is performed.
	The IRIS button does not work at this
	time.
	OFF:
	The auto iris control operation is not
	performed even if the AUTO button is
	pressed.
	The iris control operation selected by the
	IRIS button is performed.
AGC	For setting the auto gain control operation
(Camera)	when ON is selected as the A. IRIS item
	setting.
	6 dB:
	Auto gain control up to 6 dB is performed
	when the AUTO button is pressed.
	12 dB:
	Auto gain control up to 12 dB is
	performed when the AUTO button is
	pressed.
	OFF:
	Auto gain control is not performed even
	if the AUTO button is pressed.
ATW	ON:
(Camera)	The ATW (auto tracking white balance)
	function operation is set to ON or OFF
	using the AUTO button.
	At this time, the operation of this function
	cannot be set to ON or OFF using the
	WHITE BAL switch and USER button.
	However, when ATWLOCK is allocated
	to the USER button, the white balance
	value can be fixed using the USER
	button.
	OFF:
	The ATW function operation is not
	performed even if the AUTO button is
	pressed.
	The ATW function operation selected by
	the WHITE BAL switch is performed.
AF	ON:
(Camera)	When the AUTO button has been
	pressed, the auto focus operation is
	performed.
	The FOCUS switch and PUSH AUTO
	button do not work at this time.
	OFF:
	The auto focus operation is not
	performed even if the AUTO button is
	pressed.
	The focus operation selected by the
	FOCUS switch and PUSH AUTO button
	is performed.

PLAYBACK FUNCTIONS screen

Item/	Description of settings	ENGLISH
(display mode)
END SEARCH	For setting what kind of operation is to be
(VCR)	performed when the EVF DTL/END
	SEARCH button is pressed.
	BLANK:
	The unrecorded blanks on the video tape
	are searched.
	REC END:
	The part which was shot last is
	searched.
	<Notes>
	O Even when the REC END setting is
	selected, the part which was shot last
	will not be searched when the tape is
	switched.
	O If nothing has been recorded on the
	tape, operation will stop at the end of the
	tape.
	O END SEARCH may not operate properly
	if there is an unrecorded blank near the
	tape start or at a point along the tape.
32K (12bit)	For setting the sound to be output as the
AUDIO	CH1 and CH2 signals when a tape
(VCR)	recorded in the 32K (12-bit) audio mode is
	played back.
	ST1:
	The sound recorded during shooting is
	selected.
	CH1 signals = CH1 track
	CH2 signals = CH2 track
	ST2:
	The sound recorded during audio
	dubbing is selected.
	CH1 signals = CH3 track
	CH2 signals = CH4 track
	MIX:
	The sound recorded during shooting and
	the sound recorded during audio
	dubbing are mixed.
	CH1 signals = CH1 + CH3 tracks
	CH2 signals = CH2 + CH4 tracks
	<Note>
	If the sound has been recorded in the 48K
	(16-bit) mode, there is no CH3 or CH4.
	Therefore, the correlation between the
	signals and tracks will always be as follows:
	CH1 signals = CH1 track
	CH2 signals = CH2 track

The underlining indicates the factory setting.

43 (E)