Playback

Cannot play even when I

• Make sure the MCR lamp is on (press the mode button).

P62

press the play button.

No kind of playback operation can be performed unless this lamp

 

 

is on.

 

Mosaic-like noise appears

• This noise is inherent to digital video technology.

——

when I cue or review a

This is normal.

 

tape.

 

 

Images do not appear on

• Make sure the input selector on your television is set to video

——

the television even though

input.

 

I have connected the

Read the television’s instructions carefully and select the correct

 

camera-recorder properly.

video input connector for the camera-recorder.

 

Cannot hear any sound

• You may have turned down the camera-recorder’s volume control

P74

from the camera-

too far.

 

recorder’s speaker.

Adjust the volume level using the PAGE/AUDIO MON/

 

 

VAR button+.

 

Cannot perform hot swap

• This unit does not support hot swap playback.

P85

playback.

To replace one card with another during dubbing, stop the

 

 

dubbing first, and upon completing the replacement, resume it.

 

Other

Cannot read the data on

• Make sure the SD memory card is formatted correctly.

P28

the SD memory card.

If it is not, format the card in the unit.

 

The remote control does

• The battery in the remote control may have run out.

P17

not work.

If the remote control fails to work even if it is operated close to the

 

 

remote control sensor of the camera-recorder, it means that the

 

 

battery has run out. Replace it with new one.

 

 

• Make sure the remote control setting is the same for the remote

P17

 

control unit and the camera-recorder.

 

 

If the REMOTE setting is different on the remote control and the

 

 

camera-recorder, the remote control will not work.

 

There is a rattling sound

• There are some parts of the camera that make a rattling sound

——

when the camera-recorder

in the MCR mode or when the POWER switch is OFF. This is

 

is tilted back and forth.

normal.

 

A clicking sound is heard

• This initialization operation is performed when the camera starts

——

when the power is turned

up.

 

on or when the MCR

It occurs due to the construction of the camera and is not

 

mode is switched to the

indicative of any trouble.

 

CAM mode.

 

 

Reference

115