6 Proceed with nonlinear editing using your computer.

An icon for the P2 card contents appears as a removable disk in My Computer of your computer.

•For further details, refer to the instructions for your computer’s editing software.

•When replacing one card with another, if the USB connection is used, check that the access lamp is not flashing and that the data on the card is not being accessed before ejecting the card. If the 1394 connection is used, place the drive icon into the computer’s recycle bin before ejecting the card.

•The unit cannot be operated while in PC mode.

•When the cable is to be disconnected, proceed with “Safely Remove Hardware” on the computer.

In the case of a 1394 connection, first confirm that “1394 DEVICE DISCONNECT” is displayed on the camera-recorder before disconnecting the cable. In the case of a USB connection, “USB DEVICE CONNECT” will remain displayed so check that the card is not being accessed before disconnecting the cable.

7 Switch OFF the camera.

•When turning the power off, proceed with “Safely Remove Hardware” on the computer.

In the case of a 1394 connection, first confirm that “1394 DEVICE DISCONNECT” is displayed on the camera-recorder before turning the power off. In the case of a USB connection, “USB DEVICE CONNECT” will remain displayed so check that the card is not being accessed before turning the power off.

•You cannot cancel the PC mode even if you press the mode button for more than 2 seconds.

P2 cards are compliant with the Type-II standard so you can insert them straight into the computer’s card slots and proceed with nonlinear editing.

•The Card Bus driver is contained in the CD- ROM provided.

Editing

81