Video output (encoder output) signal adjustments

After this system has been connected, the video output signal (ENCODER OUT) must be adjusted if AB roll editing (editing using two source machines) using an editor, for instance, is to be error-free and accurate. (This adjustment must be repeated when one of the connecting cables has been replaced and whenever the connections are changed.)

The adjustment procedure using this unit is outlined below.

Check the connections. (see page 22.)

Set the REMOTE/LOCAL switch on the front panel bottom section to the adjustment

p o s i t i o n

( L O C A L ) .

REMOTE:

For adjusting the video output signals using an external encoder remote

controller.

LOCAL: For adjusting the video output signals using this unit.

Adjust the source machine independently.

3-1When using the preset values

Set the PRESET/MANUAL switches of the VIDEO LEVEL, CHROMA LEVEL, SETUP and HUE controls to PRESET.

3-2When adjusting the video output signals without using the preset values

1 Play back a cassette tape on which standard color bar signals have been recorded.

2 Adjust the controls in such a way that the waveforms on the waveform monitor (WFM) and vectorscope (VSC) resemble those shown in the figures below.

Video level

Adjust this level to 100IRE.

Chroma level and hue

Adjust the two controls in such a way that the light spot of the vector waveforms comes inside the rectangular grid mark.

Setup level

Adjust the control to eliminate deviation.

Waveform on WFM

Waveform on VSC

Perform the same adjustments on the source machine connected to the unit.

- 4 1 -

Page 41
Image 41
Panasonic AJ-D750P manual Video output encoder output signal adjustments, Video level, Chroma level and hue, Setup level