Panasonic AJ-D850P manual Servo Control

Counter display	Monitor display	Description	VTR operation
			(Restart condition)
REEL DIR UNMATCH	REEL DIR UNMATCH	If the reel motor at the take-up side is running in the	STOP
		reverse direction, the AUTO OFF lamp lights, and the
		message display flashes.	(POWER OFF→ON)
REEL TENSION ERROR	REEL TENSION ERROR	If an abnormal tension at the supply side is detected	STOP
		in the reel mode, the AUTO OFF lamp lights, and the
			(POWER OFF→ON)
		message display flashes.
SERVO COMM ERROR	SERVO COMM ERROR	When the servo microcomputer does not follow the	STOP
		instructions of the system control microcomputer
		even when 10 seconds have elapsed, the AUTO OFF	(POWER OFF→ON)
		lamp lights, and the message display flashes.
SERVO CONTROL	SERVO CONTROL	When there is no response from the servo micro-	STOP
ERROR	ERR	computer for 1 or more seconds, the AUTO OFF
		lamp lights, and the message display flashes.	(POWER OFF→ON)
SERVO ERROR	SERVO ERROR	When only the servo microcomputer was reset in an	STOP
		instantaneous power failure, the AUTO OFF lamp
			(POWER OFF→ON)
		lights, and the message display flashes.
S-FF/REW TIMEOVER	S-FF/REW TIMEOVER	If the start/end processing operation is not completed,	STOP
		the AUTO OFF lamp lights, and the message display	(POWER OFF→ON)
		flashes.
S REEL ROTA TOO	S REEL TOO FAST	If the supply reel motor should rotate at an ab-	STOP
FAST		normally fast rate, the AUTO OFF lamp lights, and	(POWER OFF→ON)
		the message display flashes.
S REEL TORQUE	S REEL TORQUE	If an abnormal torque applied to the supply reel motor	STOP
ERROR	ERR	is detected, the AUTO OFF lamp lights, and the
		message display flashes.	(POWER OFF→ON)
T REEL ROTA TOO	T REEL TOO FAST	If the take-up reel motor should rotate at an ab-	STOP
FAST		normally fast rate, the AUTO OFF lamp lights, and	(POWER OFF→ON)
		the message display flashes.
T REEL TORQUE	T REEL TORQUE	If an abnormal torque applied to the take-up reel	STOP
ERROR	ERR	motor is detected, the AUTO OFF lamp lights, and	(POWER OFF→ON)
		the message display flashes.
UNLOAD ERROR	UNLOAD ERROR	If the tape has not been wound up during unloading,	STOP
		the AUTO OFF lamp lights, and the message display	(POWER OFF→ON)
		flashes.
WINDUP ERROR	WINDUP ERROR	If the tape was not wound up at less than the
		standard speed (1⋅) when the total tape amount was	STOP
		not detected or if abnormal tape slack or tension was
		detected at speeds above 1⋅ after the total tape	(POWER OFF→ON)
		amount was detected, the AUTO OFF lamp lights,
		and the message display flashes.
WINDUP REEL NOT	W-UP REEL NOT ROTA	If, after the cassette has been inserted, the tape take-
ROTA		up reel has not wound up the tape at the standard	STOP
		speed (1⋅) or faster while the total tape amount is not	(POWER OFF→ON)
		detected and while the tape is traveling in the forward
		or reverse direction, the AUTO OFF lamp lights, and
		the message display flashes.

– 91 –