Panasonic AJ-D850P manual Interface

Setup menus

USER menu

<INTERFACE>

	Item		Setting
							Description
No.	Superimposed	No.		Superimposed
	display				display
200	PARA RUN	0000			DIS	This selects whether two or more VTRs are to be operated in
		0001			ENA	synchronization.
						0: No operation in synchronization
						1: Operation in synchronization
						<Note>
						When operating two or more VTRs in synchronization, set
						item 200 of all the VTRs to 0001.
201	9P SEL	0000			OFF	This selects whether the 9P connector functions when the
		0001			ON	REMOTE/LOCAL switch has been set to REMOTE.
						0: Do not function
						1: Function
202	ID SEL	0000			OTHER	This selects the ID information which is returned to the
		0001			DVCPRO	controller.
						0: 20	25H
						1: DVCPRO’s, own ID is returned (F0 33H).
203	25P SEL	0000			OFF	This selects whether the PARALLEL (25P) connector
		0001			ON	functions when the REMOTE/LOCAL switch has been set to
						REMOTE.
						0: Does not function
						1: Functions
204	RS232C SEL	0000			OFF	These settings are for selecting whether the RS-232C
		0001			ON	connector is to function when the REMOTE/LOCAL switch is
						set to REMOTE.
						0: Connector does not function.
						1: Connector functions.
205	BAUD RATE	0000		300		These settings are for selecting the RS-232C communication
		0001		600		speed (baud rate).
		0002		1200
		0003		2400
		0004		4800
		0005		9600
206	DATA	0000		7		These settings are for selecting the RS-232C data length.
	LENGTH	0001		8		(Unit: bit)
207	STOP BIT	0000			1	These settings are for selecting the RS-232C stop bit length.
		0001		2		(Unit: bit)
208	PARITY	0000			NON	These settings are for selecting the none, odd or even for the
		0001			ODD	RS-232C parity bit.
		0002			EVEN	0: Parity bit is not used.
						1: An odd number of bits is used for the parity system.
						2: An even number of bits is used for the parity system.
209	RETURN	0000			OFF	These settings are for selecting whether the ACK code is to be
	ACK	0001			ON	returned when a command is received from RS-232C.
						0: ACK code is not returned.
						1: ACK code is returned.
210	25P STBY	0000			OFF/ON	This selects the method used to detect the STANDBY
	CMD	0001			ON	COMMAND signal input at the PARALLEL (25P) connector.
						0: Each time active signals are detected, the STANDBY ON or
						STANDBY OFF mode is selected alternately.
						1: When active signals are detected in the STANDBY OFF
						mode, the unit is transferred to the STANDBY ON mode.
						No effect is exerted on operation while the STANDBY ON
						mode is established.

The underline on the setting item denotes the initial setting.

– 62 –