70
When the PLAY/PAUSE button is pressed, the
playback pictures can be monitored in black and white
on the viewfinder screen.
These playback pictures can be monitored in two
other ways.

Rec review

When recording is temporarily stopped and the lens
RET button is pressed, the last two seconds of the
tape are automatically rewound, and the playback
pictures on this part of the tape appear on the
viewfinder screen. This makes it possible to check
whether recording was performed properly.
After the two seconds of the tape have been played
back, the unit is again set to the recording start
standby mode.
If the RET button is held down, a maximum of 10
seconds of the tape is rewound and played back.
<Note>
The rec review function cannot be used unless
recording lasts for one or more seconds.

Color playback

When an HD color monitor is connected to the unit’s
HD SDI OUT connector, color playback pictures can
be monitored.
The playback signals will be output to the viewfinder
even during rewinding (REW) or fast forwarding (FF).
Selecting the audio output of the playback signal and
adjusting the volume are accomplished using the
MONITOR switch control (page 11).
Playback (checking what has been recorded)
Depending on the internal VTR status, the RET button
functions which appear on the viewfinder screen
change as follows.
Lens RET button functions
Internal VTR
status What appears on the viewfinder screen
Pictures which are shot by the camera
(RET button does not work)
During recording
What has just been recorded (rec review of 2
seconds of the tape recording) can be checked.
During rec-
pause
Playback pictures of internal VTR
(RET button does not work)
During playback
Pictures accompanying operation to locate the
scene-to-scene continuity point
During play-
pause