Panasonic AJ- P, AJ-HDC27V operating instructions Scene-to-scene continuity, During rec-pause

Recording

Scene-to-scene continuity

If the unit is in the rec-pause mode, it is possible to ensure scene-to-scene continuity with an accuracy of

0 up to 1 frame just by pressing the VTR START button or lens VTR button.

If the unit is in a mode other than rec-pause, the point at which the scene-to-scene continuity is to be maintained must be located before recording is started.

During rec-pause

The scene-to-scene continuity timing is located automatically. However, the time taken until the start of recording differs depending on the setting of the VTR SAVE/STBY switch.

OWhen the VTR SAVE/STBY switch is set to SAVE, recording commences about two seconds after the VTR START button is pressed.

OWhen the VTR SAVE/STBY switch is set to STBY, recording commences as soon as the VTR START button is pressed.

Ensuring scene-to-scene continuity after the power was turned off while the unit was in the rec-pause mode

1	Switch the power back on.
2	Press the VTR START button or lens VTR button
	to start the recording.

2 1

Ensuring scene-to-scene continuity at other times

Proceed as follows either after the tape has been allowed to run or after the cassette has been ejected or when ensuring continuity on a tape which has been recorded only in part.

1	While monitoring the viewfinder screen, press the
	PLAY/PAUSE button to play back the tape.
2	At the place on the tape where continuity is to be
	maintained, press the PLAY/PAUSE (or STOP)
	button again to stop the tape.
3	Press the lens RET button. It takes	about two
	seconds to complete the preparations	for the
	scene-to-scene continuity.
4	Press the VTR START button or lens VTR button
	to start the recording.
	1,2	3

4

69