Panasonic AJ-SD955BE, AJ-SD930BE manual Parallel Remote connector, Analog Audio OUT connectors, Fan

CONTENTS

Parts and their functions

Rear panel

AC IN

SIGNAL

GND

AES/EBU		ANALOG
CH1/2			VIDEO
IN
			IN
			ON
CH3/4	Y		75Ω
IN			OFF
CH1/2	PB		REF VIDEO
OUT			IN
			ON
CH3/4	PR		75Ω
OUT	OPTION		OFF
	Y	1	VIDEO
			OUT

PB2 (WFM)

PR3 (SUPER)

SERVICE ONLY

REMOTE

REMOTE IN/OUT

REMOTE OUT

ENCODER REMOTE

RS-232C

PARALLEL

	ANALOG
CH1 PUSH AUDIO PUSH CH2			PUSH	TC
	IN			IN
CH3 PUSH		PUSH CH4		TC
				OUT
CH1	AUDIO	CH2		MON
	OUT			L
CH3		CH4		MON
				R

	SDI
IN	OUT

1

ACTIVE

THROUGH

2

3

(SUPER)

OPTION

SDTI

IN OUT

1

2

APARALLEL REMOTE connector

This connector is used when the VTR is to be operated by an external component.

BANALOG AUDIO OUT connectors

The analogue audio signals are output through these connectors.

= <

> ?@ A B C D

CMONITOR OUT connectors

During playback, the PCM audio signals

(CH1/CH2/CH3/CH4) or playback signals from the

CUE track are output through these connectors.

<Fan

This fan is used to cool down the VTR.

If, for any reason, the fan stops, “E-10” will appear on the counter display.

=SIGNAL GND terminal

This is connected to the signal ground terminal on the component connected to this VTR in order to minimize noise. It is not a safety ground.

>ANALOG COMPONENT VIDEO OUT connectors The analogue component video signals are output through these connectors.

?ANALOG COMPOSITE VIDEO OUT connectors The analogue composite video signals are output through these connectors.

The waveform monitor (WFM) signal can be output from the VIDEO OUT 2 connector.

It can be selected using setup menu No. 00 (WFM SEL).

Video signals containing superimposed information can be output through the VIDEO OUT 3 connector. Whether the superimposing is to be set ON or OFF is selected using the SUPER switch W on the front panel.

@RS-232C connector

A personal computer or other component can be connected to this connector to operate the VTR.

<Note>

Noise may appear on the CUE signal at the instant

recording is started.

DSDTI input and output connectors (optional) When the SDTI board (AJ-YAC930G, optional accessory) is installed in this VTR, digital data can be input and output using the SDTI (Serial Data Transport Interface) format.

IEEE1394 digital input/output connector (optional)

Use of an digital video interface board (AJ- YAD955G, optional accessory) enables input/output interfacing of the digital signals with the IEEE1394 standard.

15 (E)