CS-E9DKEW CU-E9DKE / CS-E12DKEW CU-E12DKE

Attached accessoriesIndoor/Outdoor Unit Installation Diagram

Applicable piping kit

CZ-3F5, 7BP (E9DK)

CZ-4F5, 7, 10BP (E12DK)

SELECT THE BEST LOCATIONINDOOR UNIT

•There should not be any heat source or steam near the unit.

•There should not be any obstacles blocking the air circulation.

•A place where air circulation in the room is good.

•A place where drainage can be easily done.

•A place where noise prevention is taken into consideration.

•Do not install the unit near the door way.

•Ensure the spaces indicated by arrows from the wall, ceiling, fence or other obstacles.

•Recommended installation height for indoor unit shall be at least 2.3 m.

OUTDOOR UNIT

•If an awning is built over the unit to prevent direct sunlight or rain, be careful that heat radiation from the condenser is not obstructed.

•There should not be any animal or plant which could be affected by hot air discharged.

•Keep the spaces indicated by arrows from wall, ceiling, fence or other obstacles.

•Do not place any obstacles which may cause a short circuit of the discharged air.

•If piping length is over the rated length, additional refrigerant should be added as shown in the table.

•This illustration is for explanation purposes only. The indoor unit will actually face a different way.

52