Panasonic DMR-ES20DEB manual Connecting with RF cable Aerial cable

Connecting with RF cable (Aerial cable)

1Aerial

RF cable /

Aerial cable

RF IN

Aerial input

F OUT RF IN

AV1 (TV)

AV2 (EXT)

RF OUT

Aerial output

2 RF cable / Aerial cable

AC IN

DVD Recorder

VIDEO			S VIDEO OUT
L		L
				Y	PB	PR
AUDIO
			S VIDEO	COMPONENT	OPTICAL	AC IN
R		R	AV4 IN	VIDEO OUT
AV4 IN	OUT			(PROGRESSIVE/	DIGITAL AUDIO OUT
				INTERLACE)	(PCM/BITSTREAM)

AC IN~

3 AC mains lead

Follow the steps below.

Disconnect the power of all units.

1Connect aerial to the RF IN (Aerial input) connector of the DVD Recorder.

2Connect the DVD Recorder´s RF OUT (Aerial output) to the TV set’s Aerial in connector.

3Connect DVD Recorder and TV set to the AC mains socket.

Follow the steps for Auto-Setup on page 14.

TV

Aerial input

AC mains lead 3

AC mains socket

DVD Display

Auto-Setup

Ch 354

Auto-Setup in progress, please wait.

RETURN: to abort

RETURN

Owner ID

PIN number * * * *

Name

House No.

Postcode

RETURN

RETURN : leave

Clock

			Automatic		Off
		Time	Date
	0 : 00 : 00		1 . 1 .	2005
0	No
	9
		Clock cannot be set automatically.
CHANGE	SELECT	Please set the clock manually.
ENTER		ENTER: store	RETURN: leave
	RETURN

Auto-Setup with RF cable (Aerial cable) (Automatic tuning)

!Turn on your television set.

!With the Standby/on switch turn on the DVD Recorder. Automatic tuning for all available TV stations begins. Approximate duration is 5 minutes.

-While Auto-Setup is running the first digit of the DVD Recorder display will flash. After a while it will stop flashing and the RF output channel number will be displayed.

-Select an unused channel pre-set on your TV and tune it to the RF output channel number shown on the DVD Recorder display (or until you can clearly see the Auto-Setup screen). Store the new RF output channel (refer to the instructions for your TV).

!After Automatic tuning has finished, the Owner ID screen will appear.

In some cases, the RF output channel may interfere with the TV stations transmitted in your area. This may prevent you from seeing the On-Screen Display clearly.

Please see page 15 for removing the interference before restarting Auto-Setup. 43

Owner ID

You can complete the Owner ID now or skip this step and do it later. To do it later, press the

RETURN button. Your DVD Recorder is now ready to use.
! To set the Owner ID now, use and press the Numeric buttons or	to enter a four-
digit PIN number. Press , to correct the digit.

!Make sure that you will remember the PIN number (make a note of it).

!Press the ENTER button twice to confirm.

!Enter the [Name], [House No] and [Postcode] in the same way, using .

!Press the ENTER button to confirm each entry.

!Press the RETURN button to leave the Owner ID screen.

!You will now see the TV picture. Your DVD Recorder is now ready to use.

If the clock setting menu appears

(Auto clock set was not possible due to a weak signal)

! Press to set the correct time and date and press ENTER to finish this setting.

Note: A wrong date or time will influence the programmed recording of TV programmes (don't forget to change summer time and winter time).

14