Quick Guide

Inserting the battery

Install the battery by inserting it in the direction shown in the figure.

AInsert the battery until it clicks and locks.

Charging the battery

ADC input terminal

1Connect the AC adaptor to the DC input

terminal.

2Connect the AC cable to the AC adaptor, then the AC outlet.

The status indicator will flash red at an interval of 2 seconds, indicating that charging has begun.

Inserting/removing an SD card

Access lamp [ACCESS] A

When this unit is accessing the SD card or built-in memory, the access lamp lights up.

12

1)Open the LCD monitor.

2)Open the SD card cover and insert (remove) the SD card into (from) the

card slot B.

Face the label side C in the direction shown in the illustration and press it straight in as far as it will go.

Press the center of the SD card and then

pull it straight out.

3)Securely close the SD card cover. ≥ Securely close it until it clicks.

Turning the unit on/off

Turning the power on and off with the power button

Press the power button to turn on the power.

AThe status indicator lights on.

To turn off the power, hold down the power button until the status indicator goes off.

Turning the power on and off with the LCD monitor

Power is turned on when the LCD monitor is opened, and power is turned off when it is closed.

To turn on the power

AThe status indicator lights on.

To turn off the power

BThe status indicator goes off.

VQT2M51

Page 12
Image 12
Panasonic HDC-SD60P/PC Quick Guide, Inserting the battery, Charging the battery, Inserting/removing an SD card