Before requesting help
General
| PROBLEM | CAUSE & REMEDY |
|
|
| I cannot make and receive | ¡The power cord or telephone line cord is not connected. Check the |
| calls. | connections (see page 12). |
|
|
| I cannot make calls. | ¡The dialing mode setting is wrong. Check the selector (see page 12). |
|
|
| The main unit does not work. | ¡Disconnect the unit from the telephone line and connect to a known |
| working phone. If the working phone operates properly, call your service |
| center to have the unit repaired. If the working phone does not operate |
| properly, contact your telephone company. |
|
|
| The handset does not work. | ¡Check the setting (see pages 11 and 13). |
| ¡Charge the battery fully (see page 13). |
| ¡Clean the charge contacts and charge again (see page 63). |
|
|
| The main unit does not ring. | ¡The ringer volume is set to OFF. Press (VOLUME) (Y) when the main |
| unit is idle. |
|
|
| The handset does not ring. | ¡The ringer volume is set to OFF. Press (VOLUME/RINGER) when the |
| TALK/BATT LOW indicator light is off. |
|
|
| The REDIAL/PAUSE button | ¡If this button is pressed during dialing, a pause will be inserted. If this |
| does not function properly. | button is pressed immediately after obtaining a dial tone, the last |
| number dialed will be redialed. |
|
|
| During programming, I cannot | ¡Whole or part of the number is the same as another code or ID. Change |
| enter the activation code or the | the number (see pages 41, 42 and 48). |
| prohibitor ID. |
|
|
|
| An alarm tone sounds when | ¡You are too far from the main unit. Move closer and try again. |
| you press (TALK) or | ¡Place the handset on the main unit and try again. |
(INTERCOM). | ¡The power cord is disconnected. Plug in the power cord. |
| An alarm tone sounds | ¡Move closer to the main unit quickly, or the call will be terminated within |
| continuously while using the | 60 seconds. |
| handset. | ¡The power cord is disconnected. Plug in the power cord. |
|
|
| Static, sound cuts in/out, | ¡Set the handset and the main unit away from electrical appliances. |
| fades. Interference from other | ¡Move closer to the main unit. |
| electrical units. | ¡Raise the main unit antenna. |
| ¡Press (CH) to change the channel. |
|
|
| The unit stops working during | ¡Place the handset on the main unit and disconnect the power cord to |
| operation. | reset. Connect the power cord, then try again. |
|
|
| You cannot store a phone | ¡You cannot store a number while the unit is in the talk, speakerphone or |
| number in memory. | intercom mode. |
| ¡Do not pause for over 30 seconds while storing. |
|
|
| While storing a phone number, | ¡To answer a call, press (TALK) or |
| the unit starts to ring. | canceled; store the number again. |
|
|
56