
Getting Started
One touch eco mode
When the handset is on the base unit, the base unit transmission power is reduced up to
99.9% if only one handset is registered. Even when the handset is not on the base unit or several handsets are registered, the base unit transmission power in standby mode can be reduced up to 90 % by activating one touch eco mode.
You can turn on/off one touch eco mode by just pressing MR/ECON. The default setting is “Normal”.
– When the one touch eco mode is on: “Low”
is temporarily displayed and is shown on the handset display instead of
.
– When the one touch eco mode is off: “Normal” is temporarily displayed and goes off from the handset display.
Note:
RWhen there is another cordless phone nearby and it is in use, the base unit transmission power may not be reduced.
RActivating one touch eco mode reduces the range of the base unit in standby mode.
RIf you set the DECT repeater mode to “On” (page 34):
–One touch eco mode is cancelled.
–“Eco Setup” is not shown in the display menu (page 24).
Dialling mode
If you cannot make calls, change this setting according to your telephone line service. The default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
1MMenuN (right soft key) #120
2 MbN: Select the desired setting.
3 MOKN a MN
14
PRW110FX(en)_0724_ver012.pdf 14
2013/07/24 13:40:25