Panasonic KX-PRW110FX Other programming, Answering the baby monitor, Changing the handset name

Programming

Baby monitor sensitivity

You can adjust the sensitivity of the baby monitor. Increase or decrease the sensitivity to adjust the sound level needed to trigger the baby monitor feature.

RThis feature cannot be set during a monitoring call.

1Press MMenuN on the handset being monitored.

2MbN: “Sensitivity Level” a MOKN

3MbN: Select the desired setting. a MOKN

a MN

Answering the baby monitor

nWhen monitoring with a handset: Press MN to answer calls.

If you want to respond from the monitoring

handset, press MN.

R The monitoring handset will answer calls automatically when the auto intercom feature is set to “On” (page 17).

Note:

R If you receive an outside call when communicating with the monitored handset, you hear 2 tones. To answer

the call, press MN, then press MN.

nWhen monitoring from an outside line: To answer a call, follow the operation for your phone.

If you want to respond from the monitoring handset, press #1 using tone dialling. You can turn off the baby monitor feature by pressing #0.

Note:

R 2 minutes after the monitored handset starts a call, communication between the monitored handset and monitoring phone line is turned off automatically.

Other programming

Changing the handset name

Each handset can be given a customised name (“Bob”, “Kitchen”, etc.). This is useful when you make intercom calls between handsets. You can also select whether or not the handset name is displayed in standby mode. The default setting is “No”. If you select “Yes” without entering any handset name,

“Handset 1” to “Handset 6” is displayed.

1MMenuN (right soft key) #104

2Enter the desired name (max. 10 characters).

3MOKN

4MbN: Select the desired setting. a MOKN

2 times a MN

Call restriction

You can restrict selected handsets from dialling certain numbers. You can assign up to 6 phone numbers to be restricted, and select which handsets are to be restricted. Storing area codes here prevents the restricted handsets from dialling any phone number in that area code.

1MMenuN (right soft key) #256

2Enter the base unit PIN (default: “0000”). R If you forget your PIN, contact an

authorised service centre.

3Select the handsets to be restricted by pressing 1 to 6.

R All handsets registered to the base unit are displayed.

R “” is displayed next to the selected handset numbers.

R To cancel a selected handset, press the same dial key again. “” disappears.

4MOKN

5Select a memory location by pressing 1 to 6. a MOKN

31

PRW110FX(en)_0724_ver012.pdf 31

2013/07/24 13:40:26