Panasonic KX-PRW110FX operating instructions Registering a unit, Operating additional units

Programming

6Edit the text memo if necessary (30 characters max.). a MOKN

7MbN: Select the desired alarm tone. a

MOKN 2 times a MN

Erasing an entry

Schedule alarm entries are not erased automatically after the schedule alarm sounds. Erase unwanted entries.

1MMenuN (right soft key) a a MOKN

2 MListN a MbN: Select the desired entry.

3 MMenuN a MbN: “Erase” a MOKN

4 MbN: “Yes” a MOKN a MN

Erasing all entries

1MMenuN (right soft key) a a MOKN

2 MListN a MMenuN

3 MbN: “Erase All” a MOKN

4 MbN: “Yes” a MOKN

5 MbN: “Yes” a MOKN a MN

Registering a unit

Operating additional units

Additional handsets

Up to 6 handsets can be registered to a single base unit.

Important:

RThe additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations may not be available.

Additional base units

Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. If a handset moves out of range of its base unit when “Auto” is selected on

base unit (page 33), it looks for another

base unit to make or receive calls. A base unit and the handsets it communicates with is called a “radio cell”.

Note:

RCalls are disconnected when the handset moves from one radio cell to another.

Registering a handset to a base unit

The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, is displayed even when the handset is near the base unit), re-register the handset.

1Handset:

MMenuN (right soft key) #130

2MbN: Select a base unit number. a MOKN R This number is used by the handset as

a reference only.

3Base unit:

Press and hold MN for about 5 seconds. R If all registered handsets start ringing, press MN again to stop, then repeat

this step.

4Handset:

MOKN a Wait until “Base PIN” is displayed. a Enter the base unit PIN (default: “0000”). a MOKN

R If you forget your PIN, contact an authorised service centre.

Selecting a base unit

When “Auto” is selected, the handset automatically uses any available base unit it is registered to. When a specific base unit is selected, the handset makes and receives calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.

1MMenuN (right soft key) #137

2MbN: Select the desired base unit number, or “Auto”. a MOKN

33

PRW110FX(en)_0724_ver012.pdf 33

2013/07/24 13:40:26