Setting the date and time, Example 330 PM

Preparation

Setting the date and time

Important:

LConfirm that the AC adaptor is connected.

LEnsure that w is not flashing. If the handset is in screen saver mode, w is not displayed. Press {ih} to turn the display on.

1Press $(middle soft key).

2Select b, then press ,.

3Select “Set Date & Time”, then press

4Enter the current day, month and year by selecting 2 digits for each.

Example: 17 May, 2005 Press {1}{7} {0}{5} {0}{5}.

5Enter the current hour and minute by selecting 2 digits for each.

LYou can select “AM”, “PM” or 24-hour time entry by pressing {*} repeatedly.

Example: 3:30 PM

Press {0}{3} {3}{0}, then press {*} repeatedly until “03:30 PM” is displayed.

6Press ,.

7Press {ih}.

Note:

LTo correct a digit, press {<} or {>} to move the cursor, then make the correction.

LThe date and time may be incorrect after a power failure. In this case, set the date and time again.

Page 12

Image 12

Panasonic KX-TG1850NZ operating instructions Setting the date and time, Example 330 PM

Contents

Model No. KX-TG1850NZ Introduction Feature highlights Making/Answering Calls Accessory information Included accessoriesAdditional/replacement accessories Battery caution Important informationGeneral Environment Controls and displays ControlsDisplays Menu Menu/feature Icon Menu iconsSoft key icons Action Key Icon Connections Soft Action Key Icon Battery installation Battery chargeBattery strength Battery icon Screen saver mode Battery replacementTurning the power on/off Setting the date and time Example 330 PM Redial feature Making calls Other features Voice enhancerTo erase numbers in the redial list Mute Answering calls Using the phonebook Adding entries to the phonebookCategories Finding and calling a phonebook entry Editing entries in the phonebook Erasing entries from the phonebookOne touch dial Making a call using a one touch dial key Chain dialCopying one entry Copying all entries Guide to handset settings Handset settings Sub-menu Default setting Menu Time settings Ringer setupAlarm Ringer volume Night mode Setting the start and end time for night modeTurning night mode on/off Setting the ring delay for night mode Display setup Selecting the standby mode displaySelecting categories to bypass night mode Selecting wallpaper Call options Other options Resetting the handset to its default settings Turning keytones on/off Guide to base unit settings Base unit Sub-menu Default setting Settings menu Night mode Setting pause length Changing the recall timeStoring/changing emergency numbers Selecting area codes to be deleted automatically Setting call restriction Codes which you want the unit to delete automatically Resetting the base unit to its default settings Using Caller ID service Category features for Caller ID subscribers Caller list Viewing the caller list and calling backEditing a caller’s phone number before calling back Erasing caller information Call minder Storing caller information into the phonebook Operating additional units Registering a handset to a base unitAdditional handsets Additional base units Cancelling a handset Cancelling a base unitSelecting a base unit Turning the repeater mode on/off Increasing the range of the base unitHandset Multi-unit Operation Wall mounting 60 mm Screws Available character entries Character entry modes Extended 1 character table N Extended 2 character table OCyrillic character table P Troubleshooting Initial settingsProblem Cause & solution Telephone Redial the number manually Specifications Index PINPage Page Page Customer Support Centre Tel. No 272 Sales Department Copyright