Base Unit Settings
4Select “Ringer Setup”, then press
,.
5Select “Night Mode”, then press
,.
6Select “Ring Delay”, then press
,.
7Select the desired setting, then press
,.
8Press {ih}.
Call options
Changing the recall time
Change the recall time, if necessary, depending on the requirements of your service provider or PBX.
1Press $(middle soft key).
2Select Z, then press ,.
3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page
28).
4Select “Call Options”, then press
,.
5Select “Recall”, then press ,.
6Select the desired setting, then press
,.
7Press {ih}.
Setting pause length
Change the pause length, if necessary, depending on the requirements of your service provider or PBX.
1Press $(middle soft key).
2Select Z, then press ,.
3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page
28).
4Select “Call Options”, then press
,.
5Select “Pause Length”, then press
,.
6Select the desired setting, then press
,.
7Press {ih}.
Storing/changing emergency numbers
These settings determine which phone numbers can be dialled while the call bar feature is on (page 23).
1Press $(middle soft key).
2Select Z, then press ,.
3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page
28).
4Select “Call Options”, then press
,.
5Select “Emergency No.”, then press
,.
6Select a memory location, then press
,.
LIf the memory location already contains an emergency number, the number is displayed.
7Enter/edit the number, then press ,.
LTo erase an emergency number, press and hold {C/T}.
8Press {ih}.
Note:
LThe default setting for emergency numbers are stored in the first 3 memory locations. It is recommended that you do not overwrite these numbers.
Selecting area codes to be deleted automatically
In some situations, phone numbers stored automatically in the Caller ID list (page 31) will include area codes. If you do not want to dial the area codes when making calls from the Caller ID list, you can store the area
27
