Panasonic KX-TG2340JX operating instructions But Recharge battery is

PQQX14670ZA.book 57 ページ ２００５年２月２２日 火曜日 午後１２時０分

Troubleshooting

Problem Cause & Remedy

The handset and/or base unit does not announce the displayed caller’s name properly.

•Name pronunciation may vary.

•The handset and/or base unit will announce each letter of abbreviations, such as “Co.” and “Inc.”.

•Caller ID supports names of up to 15 letters. If the caller’s name has more than 15 letters, the name will not be announced correctly.

The handset display exits the	• Do not pause for over 60 seconds while
Caller List or phone book.		searching.
“Recharge battery” is	• Fully charge the battery (p. 9).
displayed, “7” flashes, or
the handset beeps
intermittently.
“Charge for 6h” and “8”	• The battery has been discharged. Fully
are displayed and the handset		charge the battery (p. 9).
does not work.	• Check battery installation (p. 9).
You charged the battery fully,	• Clean the charge contacts and charge again
but “Recharge battery” is		(p. 10).
still displayed and/or “7”	• The battery may need to be replaced. If you
continues to flash, or “Charge		install a new battery, fully charge it (p. 9).
for 6h” and “8” are
displayed.
Time setting is erased, and “E	• If a power failure occurs, time setting may be
Press MENU.” flashes on the		erased. Set the date and time again (p. 13).
handset display.
The CHARGE indicator does	• This is normal.
not go out after the battery has
been charged.
You cannot have a	• Make sure the optional headset is connected
conversation using the		properly (p. 52).
headset.	• If “SP-phone” is displayed on the handset,
		press [C] to switch to the headset.
			Useful Information
	57