Special programming
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each handset.
Important:
RSet the date and time beforehand (page 12).
Handset
1MMENUN#720
2MbN: Select the desired alarm option. a
MSELECTN
Off Turns alarm off. Go to step 7.
Once An alarm sounds once at the set
time.
Daily An alarm sounds daily at the set
time. Go to step 4.
3Enter the desired month and date. a MOKN
4Set the desired time.
5MAM/PMN: Select “AM” or “PM”. a MOKN
6MbN: Select the desired alarm tone. a
MSELECTN
RWe recommend selecting a different ringer
tone from the one used for outside calls.
7MSELECTN a MOFFN
RWhen the alarm is set, is displayed.
Note:
RTo stop the alarm, press MOFFN or place the
handset on the charger.
RWhen the handset is in use, the alarm will not
sound until the handset is in standby mode.
Silent mode
Silent mode allows you to select a period of time
during which the handset will not ring for outside
calls. This feature is useful for time periods when
you do not want to be disturbed, for example,
while sleeping. Silent mode can be set for each
handset.
Important:
RSet the date and time beforehand (page 12).
RWe recommend turning the base unit ringer off
(page 14) in addition to turning the silent mode
on.
RIf you have set the alarm, the alarm sounds
even if the silent mode is turned on.
Turning silent mode on/off
Handset
1MMENUN#238
2MbN: Select the desired setting. a MSAVEN
RIf you select “Off”, press MOFFN to exit.
3Enter the desired hour and minute you wish to
start this feature.
4MAM/PMN: Select “AM” or “PM”. a MOKN
5Enter the desired hour and minute you wish to
end this feature.
6MAM/PMN: Select “AM” or “PM”.
7MSAVEN a MOFFN
RWhen the silent mode is set, is
displayed.
Changing the start and end time
Handset
1MMENUN#237
2Continue from step 3, “Turning silent mode on/
off”, page 25.
Changing the handset name
Each handset can be given a customized name
(“Bob”, “Kitchen”, etc.). This is useful when you
make intercom calls between handsets. You can
also select whether or not the handset name is
displayed in standby mode. The default setting is
“No”. If you select “Yes” without entering any
handset name, “Handset 1” to “Handset 6” is
displayed.
Handset
1MMENUN#104
2Enter the desired name (max. 10 characters;
see the character table, page 17).
RIf not required, go to step 3.
3MSAVEN
4MbN: Select the desired setting. a MSELECTN
2 times
5MOFFN
For assistance, please visit http://www.panasonic.com/help 25
Programming
TG477x(en-en)_1130_ver021.pdf 25 2011/11/30 15:57:55