Programming
used. If a handset moves out of range of its base unit when “Auto” is selected on base unit (page 29), it looks for another base unit to make or receive calls. A base unit and the handsets it communicates with is called a “radio cell”.
Note:
L Calls are disconnected when the handset moves from one radio cell to another.
Registering a handset to a base unit
The supplied handset and base unit are
1Handset:
K (centre of joystick) i N i
M
2{V}/{^}: “Registration” iM 2 times
3{V}/{^}: Select a base unit number. i M
L This number is used by the handset as a reference only.
4Base unit:
Press and hold {x} for about 5 seconds. (No registration tone) L If all registered handsets start
ringing, press the same button to stop. Then repeat this step.
L The next step should be completed within 90 seconds.
5Handset:
Wait until “Enter Base PIN” is displayed. i Enter the base unit PIN (default: “0000”). i M L If you forget your PIN, contact
your nearest Panasonic service
centre.
L When the handset has been registered successfully, w stops
flashing.
Note:
L When you purchase an additional handset, refer to the additional handset’s installation manual for registration.
Selecting a base unit
When “Auto” is selected, the handset automatically uses any available base unit it is registered to. When a specific base unit is selected, the handset makes and receives calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.
1K (centre of joystick) i N i
M
2{V}/{^}: “Select Base” i M
3{V}/{^}: Select the desired base unit number, or “Auto”. i M L The handset starts searching for
the base unit.
Deregistering a handset
A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This allows the handset to end its wireless connection with the system.
1K (centre of joystick) i ! i
M
2{3}{3}{5}
3{V}/{^}: “Deregistration” i
M
29
