Useful Information
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message | Cause/solution |
Check Tel Line | L The supplied telephone line cord has not been |
| connected yet or not connected properly. Check the |
| connections (page 11). |
Failed | L Phonebook copy failed (page 21). Confirm the other |
| handset (the receiver) is in standby mode and try |
| again. |
Incomplete | L The receiver’s phonebook memory is full. Erase the |
| unnecessary phonebook entries from the other |
| handset (the receiver) and try again. |
Memory Full | L The phonebook memory is full. Erase unnecessary |
| entries (page 20). |
| L The bar call list memory is full. Erase unnecessary |
| entries (page 28). |
| L The maximum number of base units (4) is already |
| registered to the handset. Cancel unused base unit |
| registrations from the handset (page 30). |
No link to base. | L The handset has lost communication with the base |
Reconnect AC | unit. Move closer to the base unit and try again. |
adaptor. | L Unplug the base unit’s AC adaptor to reset the unit. |
| Reconnect the adaptor and try again. |
| L The handset’s registration may have been cancelled. |
| |
Use rechargeable | L A wrong type of batteries such as Alkaline or |
battery. | Manganese was inserted. Use only the rechargeable |
| |
You must first | L You must subscribe to a Caller ID service. Once you |
subscribe to | receive caller information after subscribing to a Caller |
Caller ID. | ID service, this message will not be displayed. |
39
