Programming
Incoming call barring (Caller ID subscribers only)
This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. You can store up to 20 phone numbers in the bar call list by using the caller list or by entering the numbers directly.
When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the bar call list, the unit sends out a busy tone to the caller, then disconnects the call.
Important:
L You must store the phone number with an area code in the bar call list.
L When the unit receives a call from a number that is stored in the bar call list, the call is disconnected and the number is logged in the caller list (page 32) with 7.
Storing unwanted callers from the caller list
1K (centre of joystick) i j i
M
2{V}/{^}: Select the item to be barred. i K
3{V}/{^}: “Add Bar List” iM
4 {ih}
Storing unwanted callers by entering phone numbers
1K (centre of joystick) i # i M i ~
2Enter the phone number (24 digits max.). i M
L To erase a digit, press {C/T}.
3{ih}
Viewing/editing/erasing bar call numbers
1K (centre of joystick) i # i
M
2{V}/{^}: Select the desired item. i K
LTo exit, press {ih}.
3Proceed with the desired operation.
■Editing a number:
{V}/{^}: “Edit” i M i Use the joystick to move the
cursor. i Edit the number. i M i {ih}
■Erasing a number:
{V}/{^}: “Erase” i M i
{V}/{^}: “Yes” i M i {ih}
Note:
L When editing, press the desired dial key to add, {C/T} to erase.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to a single base unit.
Important:
L The additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc.) may not be available.
Additional base units
Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be
28
