Liquid damage Problem Cause/solution

Useful Information

Liquid damage

Problem	Cause/solution
Liquid or other form of moisture	L Disconnect the AC adaptor and telephone line
has entered the handset/base	cord from the base unit. Remove the batteries
unit.	from the handset and leave to dry for at least
	3 days. After the handset/base unit are
	completely dry, reconnect the AC adaptor and
	telephone line cord. Insert the batteries and
	charge fully before use. If the unit does not
	work properly, contact your nearest
	Panasonic service centre.

Caution:

LTo avoid permanent damage, do not use a microwave oven to speed up the drying process.

Page 44

Image 44

Panasonic KX-TG8301NZ operating instructions Liquid damage Problem Cause/solution

Contents

Model No. KX-TG8301NZ Caller ID Service Voice Mail ServiceIntroduction Preparation Accessory information Supplied accessoriesAdditional/replacement accessories Product information Expanding your phone system For your safety Rechargeable Ni-MH batteries AAA R03 size BatteryGeneral notices Important safety instructions For best performanceImportant notice Base unit location/avoiding noise Introduction Controls Base unitHandset Charge contacts B x Locator Using the joystick To adjust the receiver or speakerDisplay Soft keys Connections If you subscribe to a DSL/ADSL service Battery installation and replacementDuring a power failure Battery charge Battery level Battery icon Screen saver mode Turning the power on/offSetting up the unit before use Display language Time Settings Set Date & Time Belt clipHeadset optional Date and time Making calls Useful features during a call Answering callsMute Recall/flash Key lock Handset voice enhancerCall share Call privacy Handset phonebook Adding entriesCategories Finding and calling a phonebook entry Editing entries Erasing entriesOne touch dial One Touch Dial Copying phonebook entries Chain dialCopying an entry Copying all entries Programmable settings Ringtone*2, *3 Night Mode Start/EndOn/Off Ring Delay 60 sec Select Category Programming by scrolling through the display menus Programming Programming Special instructions for programmable settings Memo alarmTime adjustment Caller ID subscribers only Once Ringer Setup iM Night modeTime Adjustment Changing the base unit PIN Personal Identification Number Setting call restrictionSelecting area codes to be deleted automatically Registering a unit Incoming call barring Caller ID subscribers onlyOperating additional units Add Bar List iM Registering a handset to a base unit Deregistration Increasing the range of the base unit Cancelling a base unitSetting the repeater mode Using Caller ID service Caller ID featuresUsing toll services from Telecom or another company Missed calls Category settings for phonebook Caller listViewing the caller list and calling back Editing a caller’s phone number before calling back Erasing caller information Storing caller information to the phonebookEdit and Call Add Phonebook Voice mail service Answering an intercom call IntercomMaking an intercom call Handset locator Answering a transferred call Press C to answerBase unit Press Base unit Press Handset Press ih Characters available in each character entry mode When the unit displays the character entry screenCharacter entry Character entry modes Cyrillic character table P Extended 1 character table NExtended 2 character table O Error messages Troubleshooting General use Problem Cause/solution Battery recharge Problem Cause/solution Problem Cause/solutionProgrammable settings Problem Cause/solution Making/answering calls, intercom Problem Cause/solution Caller ID Problem Cause/solution Liquid damage Problem Cause/solution Specifications Index Page PNQX1195ZA CC0608DC0 For your future referenceCustomer Support Centre Tel. No Sales Department Copyright