Programming
Note:
RCalls are disconnected when the handset moves from one radio cell to another.
Registering a handset to a base unit
The supplied handset and base unit are 
is displayed even when the handset is near the base unit),
1Handset:
(middle soft key) #130
2MbN: Select a base unit number. a 
R This number is used by the handset as
a reference only.
3Base unit:
Proceed with the operation for your model.
n 
N for about 5 seconds. (No registration tone)
n 
N for about 5 seconds, until the registration tone sounds.
R If all registered handsets start ringing, press M
N again to stop, then repeat this step.
R The next step must be completed within 90 seconds.
4Handset:
a Wait until “Base PIN” is displayed. a Enter the base unit PIN
(default: “0000”). a 
R If you forget your PIN, contact an authorised service centre.
R When the handset has been registered
successfully, 
is displayed.
Note:
R While registering, “Base in registering” is displayed on all registered handsets.
RWhen you purchase an additional handset, refer to the additional handset’s installation manual for registration.
Selecting a base unit
When “Auto” is selected, the handset automatically uses any available base unit it is registered to. When a specific base unit is selected, the handset makes and receives calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.
1
(middle soft key) #137
2MbN: Select the desired base unit number,
or “Auto”. a 
R The handset starts searching for the base unit.
Deregistering a handset
A handset can cancel its own registration to the base unit, or other handsets registered to the same base unit. This allows the handset to end its wireless connection with the system.
1
(middle soft key) #131
R All handsets registered to the base unit are displayed.
2MbN: Select the handset you want to cancel. a 
3MbN: “Yes” a 
R A confirmation tone sounds.
R The handset does not beep when cancelling its own registration.
4M
N
Cancelling a base unit
A handset can cancel a base unit that it is registered to. This allows the base unit to end its wireless connection with the system.
1
(middle soft key) #139
2MbN: Select the base unit you want to cancel. a 
3MbN: “Yes” a 
a M
N
Note:
RTo register a handset to another base unit or to the same base unit again, see page 40.
40
2012/04/27 20:24:47
