Useful Information
Error messages
Display message
Base no power
or
No link to base. Reconnect main base AC adaptor.
or
No link.
Check Phone Line
Error
Failed
Incomplete
Invalid Number
Memory Full
Use rechargeable battery.
You must first subscribe to Caller ID.
Cause/solution
RThe handset has lost communication with the base unit. Move closer to the base unit and try again.
RUnplug the base unit’s AC adaptor to reset the unit. Reconnect the adaptor and try again.
RThe handset’s registration may have been cancelled.
RWhen “No link.” is displayed during a power failure, place a handset on the base unit to supply power to the base unit.
RThe supplied telephone line cord has not been connected yet or not connected properly. Check the connections (page 10).
RRecording was too short. Try again.
RPhonebook copy failed (page 24). Confirm the other handset (the receiver) is in standby mode and try again.
RThe receiver’s phonebook memory is full. Erase the unwanted phonebook entries from the other handset (the receiver) and try again.
RYou tried to send an SMS message to a phone number saved in the phonebook, caller list, or redial list that is over 20 digits long.
RThe phonebook memory is full. Erase unwanted entries (page 24).
RMessage memory is full. Erase unwanted messages (page 48, 49).
RThe call barred list memory is full. Erase unwanted entries (page 35).
RThe schedule alarm memory is full. Erase unwanted entries (page 37).
RThe maximum number of base units (4) is already registered to the handset. Cancel unused base unit registrations from the handset (page 40).
RA wrong type of battery such as Alkaline or Manganese was inserted. Use only the rechargeable
RYou must subscribe to a Caller ID service. Once you receive caller information after subscribing to a Caller ID service, this message will not be displayed.
57
2012/04/27 20:24:48