Useful Information
Problem
I cannot register a handset to a base unit.
Cause/solution
RThe maximum number of base units (4) is already registered to the handset. Cancel unused base unit registrations from the handset (page 40).
RThe maximum number of handsets (6) is already registered to the base unit. Cancel unused handset registrations from the base unit (page 40).
RYou entered the wrong PIN. If you forget your PIN, contact an authorised service centre.
Battery recharge
Problem
The handset beeps and/ or 
flashes.
I fully charged the batteries, but
–
still flashes or
–the operating time seems to be shorter.
Cause/solution
RBattery charge is low. Fully charge the batteries (page 10).
RClean the battery ends (
, 
) and the charge contacts with a dry cloth and charge again.
RIt is time to replace the batteries (page 10).
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts in and out.
Sound quality seems to be getting worse.
The handset does not ring.
The base unit does not ring.
Cause/solution
RThe handset is too far from the base unit. Move closer.
RThe base unit’s AC adaptor is not properly connected. Reconnect AC adaptor to the base unit.
RThe handset is not registered to the base unit. Register it (page 40).
RActivating one touch eco mode reduces the range of the base unit in standby mode. If required, turn eco mode off (page 16).
RYou are using the handset or base unit in an area with high electrical interference.
RMove closer to the base unit.
RIf you use a DSL/ADSL service, we recommend connecting a DSL/ADSL filter between the base unit and the telephone line jack. Contact your DSL/ADSL provider for details.
RYou have registered a handset that is not recommended (page 4). The clearest sound quality is only possible by registering the recommended handset.
RThe ringer volume is turned off. Adjust ringer volume (page 19).
RNight mode is turned on. Turn it off (page 34).
RThe ringer volume is turned off. Adjust ringer volume (page 30).
59
2012/04/27 20:24:48
